This is an Op-amp LED flasher circuit that interesting. We have a lot of how to build dual LED flasher circuit. This is a good circuit that we seldom use them.
The two LEDs it will wink to alternate between a red LED and green LED. This circuit can work with IC LM324, by part of IC op-amp 4 pcs. number LM324 cheap build origin waves square circuit comes out 1 cycle per every second.
For LED one by one resistors serial connection stays with LED one by that one be valuable differently, because of requirement Foreard voltage differently. If LED2 stick glowing bright , while again stick ,give enhance the value of R6 a little again. value expansion of R6 too much will go to decrease the brightness of LED2 down go to power supply can use 5V sizes or 6V-9V.
Read also: DIY Flashing Bicycle LED Taillight Circuit
This op-amp LED flasher circuit has worked because my son build them on bread board happily. See below.
Note: LM324 datasheet
OP-AMP Lamp flasher circuit
This is Circuit Christmas Tree Lights Flasher with 7812 for supply regulator
and IC LM380 for Signal generator dirve relay on-off the lamp two set.
detail other see circuit.
The Christmas Tree Lights Flasher Circuit. It is Lamp flasher that interesting using LM380 for Oscillator generator
model Pulse Osc. Low Frequency for use relay switch give Lamp 220V. A lot of get for the accuracy of the circuit then must use IC 7812 DC voltage REG 12V And R1 use fine winking speed of all light bulb. The detail is other see in the circuit better.
Related circuit: 1.5V LED flasher circuit using transistor, output one LED to 5 LEDs with only one AAA battery.
Related Links
Blown Fuse indicator LED Display A Fuse be the equipment protects that use often most. Because of cheapness can use protect electronics expensive circuit. Generally when fuse torn us can know immediately. but in sometimes Fuse torn already we don’t know. such as in electricity automobile system brake system […]
Led display for battery low volt This circuit uses just integrated number circuit LM3909 and capacitors outside. It work by use NiCad battery 1.25V sizes. or The dry cell is small-sized is other. […]
GET UPDATE VIA EMAIL
I always try to make Electronics Learning Easy.
Related Posts
I love electronic circuit. I will collect a lot circuit electronic for teach my son and are useful for everyone.
I constructed this in hardware and it is not working. Is this circuit proven to be worked ?
Thank you
Hi, vick
This circuit worked my son like it.
Thanks.
I try testing your circuit diagram by using software but it is fail. I think may be have some problems such as in your diagram, pin 3 is (-) and 2 is (+) in software opposite!
Hi,Chantum TOUCH.
Thanks you comment.
Please tell me your software that use?
My son test it on breadboard it work as video above.
this isn’t working in Multisim. LED1 is constantly lit up while LED2 does not respond.
Is the given diagram really working?
Hi,Jack
Thanks for your comment.
Please test this circuit again.
Goodluck.
can you explain what is goin on in this circuit?
Very good